WOO HOO my second post!

I've been doing some forum reading on upgrading the fog lights, or replacing the complete fog light assembly with some halo's and HID's.

http://www.wholesalexenonhid.com/product.php?pid=61 any suggestions for replacement assemblies?

Is this pretty much the best choice out there? I looking at going in the range of the 6k-10K. Although can't decide cause i like the look of 10k but i also realize the light loss that comes with it.

Next purchase i want to upgrade the headlight assemblies, but haven't found any options on ebay.

If you are going to go with the stock housing (fog) then go with the H3C ones the fit and placement are the closest to the stock H3 bulbs. I would still suggest a projector type housing if using HID.

Loads of aftermarket headlights on ebay, including projector, halo, and HID for less than $200.

Ok so since i'm new, i could use a little info.

does my '02 concorde cross over with parts fitment on any other models?

my stock fogs are 9040 bulbs and yes i would prefer to go HID.

My bad, i didnt realize you had a concord limited, i suppose i could have looked at your info there to the left rather than assuming

If you want to use HID bulbs/ballasts, then I would suggest using them with projectors. You'll have to fab those up yourself.

http://cgi.ebay.com/ebaymotors/98-04-CH ... ccessories

use these projectors. i have them on my LHS and they have a beautiful cutoff

great link, thanks deef - what bulb setup u using with those projector fogs HID or factory style?

I'm going to put an HID kit in them this spring. Right now I just have halogens in them.
They have a pretty cheap halo around them, which doesn't look that bad if you just put some brighter led's in it. Or you can just leave it off, it's wired separately from the lights.