Problems and Complaints

FOTKI
by FIREM  - April 17th, 2014, 8:09 am  - in: Official Announcements

Important: Forum Best Practices For All
by BOD  - April 23rd, 2013, 9:03 pm  - in: Official Announcements

Terms of Service
by BOD  - March 15th, 2009, 8:07 pm  - in: Official Announcements

Long Cranks Before Starting

• 1
• 2
• 3
• 4
• 5
• 6

by MY300M  - December 7th, 2011, 9:11 pm

*Gas tank straps--check yours if over 7 yrs old*

• 1
• 2
• 3

by EasyRider300M  - September 19th, 2009, 12:30 am

Stupid question, ..if my negative battery cable isn't on the post tight, will that cause no power?
by jim2891  - September 16th, 2023, 5:11 pm

Transmission hard shift
by cin993  - September 15th, 2023, 8:40 am

Rocker Arm Tick
by In-trepid  - November 12th, 2017, 1:01 pm

PCV hose replacement?
by LUNAT1C  - September 4th, 2023, 3:40 pm

PCM - 2003 Chrysler 300m Special
by e-peezy  - August 19th, 2023, 2:30 pm

slow motion Transaxle leak
by Countachqv  - August 23rd, 2023, 1:57 pm

Timing belts and cam gear alignment
by MoPar~Guy  - July 8th, 2023, 8:48 am

no oil pressure warning light
by turboapc  - August 16th, 2023, 2:01 am

Brake master cylinder faulty?
by OttoOlin  - July 24th, 2023, 9:42 am

Shifter cable for a 2002 Chrysler 300M
by jrouter300M  - August 8th, 2023, 9:16 pm

Best method to prevent cam from snapping over?
by LUNAT1C  - October 28th, 2018, 7:29 pm

'99 LHS Brake fitting leak
by GoofySenior  - August 1st, 2023, 11:37 am

Positive Battery Cable & Fusible Link Replacement
by mrnrod  - August 2nd, 2023, 10:00 am

Cable 5114093AA
by Dschwartz  - July 31st, 2023, 10:12 am

Hood closed, hood release cable not connected!!!!!! whaaaaa
by telenova  - August 5th, 2014, 12:47 pm

Time for the crusher?
by user97  - June 27th, 2023, 8:30 pm

Solving Oil Leak
by monte4  - June 22nd, 2023, 3:37 pm

Trunk harness typical issues, confirming fault?
by LUNAT1C  - June 16th, 2023, 5:06 pm

One Touch Down Not Working
by Herb59  - June 26th, 2023, 4:46 pm

A/M Electroluminescent module
by rustybronco  - June 16th, 2023, 9:18 am

Stumbling When Starting
by M-Pressive  - June 22nd, 2023, 11:45 am

'High Carbon Brake Rotors"
by cin993  - June 19th, 2023, 9:59 pm

Fuel Line Repair Help
by Stevelaz  - December 1st, 2022, 3:55 pm

AC vent question
by HFK  - June 18th, 2023, 9:34 pm

Air Conditioner Problem
by M-Pressive  - June 16th, 2023, 8:49 pm

Head Gasket or Bleeding/Air
by Jim Slayer  - May 19th, 2023, 8:19 am

AC compressor pulley part#
by cin993  - May 30th, 2023, 12:09 pm

Fixing chrome window trim
by Adrian63  - May 31st, 2023, 2:46 pm

misfire, cylinder 5, p0305 pending
by cin993  - May 24th, 2023, 8:55 am

Rockauto Selling Incomplete Gates Timing Belt Kits TCKWP295A
by Hi Ho Silver  - October 8th, 2011, 6:49 am

BCM Issue?
by mrnrod  - May 10th, 2023, 8:21 am

Cluster Replacement
by mrnrod  - May 10th, 2023, 7:24 am

Loud rhythmic squeal on first start on cold days only
by Nickertrip  - April 1st, 2023, 12:21 pm

Car won't move
by Travi510  - March 31st, 2023, 4:50 pm

Cylinders misfiring in the middle of long drives.
by Basheer.D  - April 24th, 2023, 2:21 pm

Terrible engine noise (with video)
by ryogenic  - April 17th, 2023, 11:08 am

Flooded Floor | Where is this windshield hole?

• 1
• 2

by Chrysler1924  - March 12th, 2013, 11:29 am

Heated Seats..sort of
by SecretAgent  - January 24th, 2009, 10:45 am

General troubleshooting of radiator fans
by sreindl  - April 4th, 2023, 10:43 am

Car won't start....timing belt ?
by Herb59  - March 31st, 2023, 11:41 am

Transmission cooler
by Herb59  - March 26th, 2023, 6:56 pm

Antifreeze leak after shutting off car
by Nickertrip  - March 17th, 2023, 7:47 am

Accumulator pistons swap for transmission valve body job
by Countachqv  - February 20th, 2023, 10:54 am

Crunching sound while sitting and turning wheel
by LUNAT1C  - February 13th, 2023, 1:43 pm

2003 300m blown engine
by Nickertrip  - February 25th, 2023, 12:14 pm

TCM fuse
by eagle4x  - February 25th, 2023, 8:24 pm

Where to start? ATC broken? Heat stuck
by 4thgenChryslerfam  - February 10th, 2023, 8:25 pm

Stripped Ignition Coil Screw
by piperdog  - June 6th, 2020, 3:45 pm