Chrysler 300M Enthusiasts Club
  • 3.5 transmission in a 2.7 300

  • Speed Sensors and ATF+4 and the like
2023 Calendar Banner

Membership Banner

Speed Sensors and ATF+4 and the like

Moderator: Moderators

 #392364  by 2.7hector
 
so i got a 2.7 300 from a aunt and it had bad transmission so i got a 3.5 transmission for it will it work
User avatar
 #392365  by FIREM
 
Need a little more information such as Year of car and donor car. Short answer is should bolt up. Due to power differences between engines final drive ratio is different.
A little more info and we a can guide you better.
2.7hector liked this
 #392368  by 2.7hector
 
so the donor car is a 2007 2.7 300 and the car we got the transmission is maybe a 2010 3.5 . i was having trouble with the 2.7 because after 40 mph it would just start over revving as it sped up. so me and my dad thought it was the transmission so we got a transmission from the junk yard
User avatar
 #392369  by FIREM
 
Well my friend sorry to say I do not know the answer to your question with certainty.
We are very familiar with the LH series of Chrysler products from 93-04.
Your 300 is the later version LX series and may have some differences. I suspect the final drive ratio will be different and would recommend checking with a trans shop or a LX based Forum to be sure
User avatar
 #392377  by LUNAT1C
 
You'll want to check something like LXForums.com, they'll have more knowledge about the 2005-2023 cars. This forums deals in the 1993-2004 cars, which are very different animals even though both platforms have 2.7 and 3.5 engines from 1998-2010. We have the 42LE 4-speed for FWD applications, you have the 42RFE for RWD/AWD applications.

It will likely bolt up, but I suspect controllers and wiring and final drive ratios will be different due to the different engine sizes, and the platform refresh in 2008 that made a number of electronics changes (I recall my 2007 Charger R/T would have needed some extra work if I wanted to use 08-10 electronic components).