Chrysler 300M Enthusiasts Club
  • My journey through my Swap to '02 Electronics LOTS OF PICS!!

  • LH Performance Modification Discussions
ROM Banner

Membership Banner

LH Performance Modification Discussions
User avatar
 #341405  by Strmvt
 January 11th, 2015, 11:29 am
Changed out the clock spring and air bag
Image
Image
Image
Image
Image
Image
Image

Also changed out the shifter assy due to the brake interlock push rod being broke when I pulled the dash.
Image
User avatar
 #341522  by Strmvt
 January 14th, 2015, 7:25 pm
Got everything I need to finish the swap except the engine hoist.

Replacing the harmonic balancer.
Image

Front crank seal
Image

Inner tie rod bushings yes Bob they have the washers Image
Image

Intake gasket set and cam locks
Image

Harmonic Balancer puller
Image

Water pump
Image
User avatar
 #341614  by Strmvt
 January 17th, 2015, 10:21 pm
Got more done on the R/T today

Motor out
Image


On the floor
Image


Old flywheel
Image


Cam caps off
Image

Cam locks bolted on
Image

Flywheel off rear main seal no leaks
Image

Motor back in forgot to take a pic of 02 flywheel mounted
Image

01 cam sprocket
Image

01 sprocket off
Imagem

Timing marks lined up
Image

Image

Balancer puller on
Image

Balancer off
Image

Water pump off and where it was leaking from
Image

Image

New water pump mounted
Image

Timing belt back on as well as the covers
Image

Image
User avatar
 #341619  by tafi300M
 January 18th, 2015, 5:41 am
Respect. :headbang Does your sister still talk to you for taking over her garage?
User avatar
 #341623  by Strmvt
 January 18th, 2015, 10:33 am
tafi300M wrote:Respect. :headbang Does your sister still talk to you for taking over her garage?
Thanks Tafi, definitly allot of work going on. Yea she does lol even made me text her when I got home lol
User avatar
 #341663  by Strmvt
 January 20th, 2015, 5:49 am
Had to buy a torch to heat up the new balancer to be able to press it on.
Image

Also got the trans harness changed.
Only got the fuel line and fuel return line to change out and inner tie rod bushings, need to get a socket lol don't have a 22m socket.

After that put the top of the motor back together. Then hopefully turn the key and not have to much trouble and she starts up Image Image Image
User avatar
 #342167  by Strmvt
 January 30th, 2015, 3:36 pm
You'd be right. Had to get a different alternator due to the differences in plug type btwn 01 and 02 model years. Found this locally thanks to Craig figured might as well lol. Just need to clean it up before install it.
Image
User avatar
 #342182  by Strmvt
 January 30th, 2015, 11:42 pm
Just need to put in the starter solder the alternator wires and mod the plenum brackets for the spacer get nuts and bolts for the front L brackets and get a new radiator.